![]() ![]() Place the "battery+power module" pack underneath using the velcro included in the package.There are several ways to do this, but here's a quick one: a) cut the connectors and solder battery and power module together (do it one at a time, being very mindful of short circuits) b) cut the other end of the power module and resolder the battery connector (previously cut) at that location Done! This will allow us to easily connect and disconnect the "battery+power module" to the drone. Adjust the power module connectors to the battery ones. If your RPi didnt install the OS or you want to reinstall it, you can download.Put together the power ( red) and ground ( black) ends of the ESCs into the individual cable (to be connected later to the battery) and fix everything underneath the frame.With a Pi3(+) you get more USB ports (diversity, serial ports via FTDI. Fix the ESC (Electronic Speed Controllers) to the frame using some tape and connect them to the motors. Recommended hardware: Ground-Station: Raspberry Pi3B(+) Air-Unit: Raspberry Pi3A+.Get the black frame together and place the motors on top. Ievgenii‘s underwater drone uses a Raspberry Pi 3 Model B sbc, Pi camera module and SparkFun Triple Axis Accelerometer and Gyro Breakout MPU-6050.If you purchase using a shopping link, we may earn a commission. To keep things this way, we finance it through advertising and shopping links. This is where the fun of DIY hardware comes in. 50 Cool Raspberry Pi Projects for April 2023 All3DP This article is free for you and free from outside influence. ![]() Once you get all the components start by assembling them.
0 Comments
Leave a Reply. |